How To Apply and Care

How To Apply

SHAKE

Before using the Magnetic Liner bottle, shake it vigorously for a few seconds. After each use, seal the bottle to prevent drying out the product.

SWATCH

To be sure that you aren't allergic to any ingredients in the magnetic liner, please swatch the product. If no reaction occurs, proceed to application.

TRIM

If you need to trim the lashes, make sure to cut the band so that the end is a magnet.

Application

STEP 1. APPLY MAGNETIC LINER

Eyeliner should be carefully applied as close as possible to the root of your lashes. Ensure that you use enough eyeliner on the brush before applying. The line should be the same thickness as the size of the magnets on the lashes. 

The magnets at the ends of the lash band have to be able to hold on correctly, so line from your inner to outer corner. Start applying your Magnetic liner where your natural lashes begin, and finish where your lashes end. 

A wing is optional. Wait 20-60 seconds depending on how much liner you applied. The liner should be about 80% dry before magnetizing lashes.

For an easier application, angle the brush parallel to your lash line and prop up your hand on your cheekbone with your pinky. 

If you prefer your own liner, you can use our magnetic liner as a top layer. To blend your lashes better, curl your lashes after liner application and apply mascara! We don’t suggest you apply mascara onto Lashnetix lashes as that may ruin them prematurely.

STEP 2. REMOVE MAGENTIC LASHES

After removing the lashes from the case, soften the eyelash band by gently bending it so that it better fits the shape of your eye.

STEP 3. APPLY LASHNETIX LASHES

Hold the magnetic eyelash toward the center of the band.
Position a mirror at chin level and look down while making contact with the magnetic strip and eyeliner. Make sure that the middle of the band is aligned with the middle of your eye. 


First make contact with the outer corner, then gently press the lash onto the inner corner. Get the band as close to your natural lashes as possible. This can be accomplished by pinching the natural and fake lashes together. In case you have long eyelashes, make sure you get behind them to avoid interference with eyeliner-to-magnet contact. Once lashes make contact with liner, grab lashes near the root and press into place to make sure it sets properly.

Cleaning and Removal

REMOVAL

Remove your eyelashes gently, and clean your eyelids using a cotton bud with an oil-based cleanser (micellar water, waterproof makeup wipes, coconut oil, etc).

CLEANING

Scratch off any dried magnetic liner that may be stuck to the magnets using your thumb nail. To clean your magnets, gently wipe them with makeup remover wipes or using a cotton bud. Use the wipe to clean off the magnetic strip in the box as well, then magnetise the lashes back into the box! DO NOT get the lashes wet as this could ruin their curl and shape!